● Before folding the rear seat backrest, ensure that there is no object within the reversing range of the rear seat backrest. Tall occupant head restraints adjustment method When adjusting the head restraints, tall passen- gers should lift head restraints to limit position as far as possible. Head restraints WARNING If the vehicle in the removal of head restraints or head restraints installation/adjustment of the case of improper driving, once an accident or rapid acceleration or emergency braking is easy to cause serious casualties! Introduction This chapter contains information on the follow- ing subjects:
● The head restraints must be installed in the car seat, and the head restraints should be adjusted correctly. – Adjusting the head restraints 70 – Head restraints removing and installing 70 The following sections describe how to adjust and remove the head restraints. Make sure you're sitting correctly → page 28. ● All drivers and passengers must adjust the head restraints to their body shape to avoid neck injury due to accidents. The upper edge of the head restraints must be as high as possible above the occupant's head, but not lower than the eyes. The back of the head should be as close to the head restraints as possible while driving. The car seats are equipped with head restraints.
The rear seat centre head restraints is designed for the rear seat centre, so the head restraints cannot be installed on other seats. There are bayonets in the support rod of the head restraints, so the head restraints can be stuck in different positions. Only properly instal- led head restraints can be clamped on bayonets in the setting range. To prevent incorrect remov- al of the head restraints after assembly, a stop is provided above and below the adjustment range. ● Do not adjust the head restraints while the vehicle is moving. NOTICE When removing and assembling the head re- straints, be sure not to collide with the roof or other parts of the car.
Otherwise, the roof or oth- er parts of the car may be damaged. The correct position of the head restraints Adjust the head restraints so that the upper edge of the head restraints is equal to the top of the head, but not lower than the eyes. The back of the head should be as close to the head re- straints as possible when the vehicle is driving. Short occupant head restraints adjustment method Small passengers should press the head re- straints down to the lowest clamping position when adjusting the head restraints. Even so, the top of the passenger's head may still be lower than the upper edge of the head restraints.
There may still be a gap between the head restraints and the top of the backrest when the head re- straints is in the lowest position. 182.5C1.TRO.74 Seats and head restraints 69