Install the front seat head restraints – Align the head restraints guide bar with the catheter on the corresponding seat back and insert it into the catheter. Seat functions – Press button → Fig. 60 1 and push down the headrests. Seat centre armrest – After installation, adjust the head restraints to the correct position according to your body type → page 28. Remove rear seat head restraints – Unlock the rear seat backrest and flip it slightly forward → page 65. – Push head restraints up into stop position → in Introduction on page 69. – Insert the open vehicle key head or screwdriv- er cutter head into the slot of the sheath → Fig. 61 1 . Fig.
62 Front seat centre armrest – Use the car key or screwdriver to hold the un- locking device in the direction of the arrow. – Press button → Fig. 61 2 at the same time, and another person will pull the head re- straints out completely. – Push the backrest back in place to lock it. Install the rear seat head restraints – Unlock the rear seat backrest and flip it slightly forward. – Align the head restraints with the head re- straints guide and insert it into the guide. Fig. 63 Rear fold-out centre armrest – Press and hold button → Fig. 61 2 while push- ing down the head restraints. Adjust the front centre armrest If needed To fold back:
fold the centre armrest upwards in the opposite direction of the ar- row → Fig. 62 A and push it into the backrest as far as it will go. – Push the backrest back in place to lock it. – After installation, adjust the head restraints to the correct position according to your body type → page 28. If needed To fold down: pull the loop on the cen- tre armrest in the direction of the arrow. If needed To adjust the positions of the centre armrest, push the armrest forward along the di- rection of B , or push backwards if it is stuck. 182.5C1.TRO.74 Seats and head restraints 71