User's Guide Solving Problems ❏ Do not load more than the maximum number of sheets specified for the paper. For plain paper, do not load above the line just under the d symbol inside the edge guide. ❏ Insert the paper cassette all the way. ❏ When paper does not feed after replacing the maintenance rollers, the rollers may not have been replaced correctly. Check if they have been replaced correctly. ❏ If you have added optional paper cassette units, you need to make settings in the printer driver. ❏ When a no-paper error occurs although paper is loaded in the rear paper feed, load paper again in the center of the rear paper feed.
❏ When multiple sheets of paper feed at once during manual 2-sided printing, remove any paper which is loaded in the paper source before you reload the paper. ❏ Load and eject paper without printing to clean the paper path. ❏ Close the front cover if you opened it during printing. Keeping the –front cover open during printing pauses the print job. ❏ The maintenance rollers may be at the end of their service life. Select Setup > Maintenance > Maintenance Roller Information > Maintenance Roller Status , and then replace the maintenance rollers as necessary. ❏ Do not open the rear cover while printing. This causes a paper jam.
❏ Make sure the paper size and paper type settings of the paper source are correct. ❏ Enable Paper Feed Assist Mode in the System Administration > Printer Settings menu when multiple sheets of paper are fed at the same time from paper cassette 1.
Related Information & “Environmental Specifications” on page 191 & “Available Paper and Capacities” on page 38 & “Paper Handling Precautions” on page 38 & “Loading Paper in the Paper Cassette” on page 42 & “Loading Paper in the Rear Paper Feed” on page 44 & “Loading Paper in the Front Paper Feed Slot” on page 46 & “Replacing Maintenance Rollers in Paper Cassette 1” on page 120 & “Replacing Maintenance Rollers in Paper Cassette 2 to 4” on page 124 & “Setting the Optional Paper Cassette Unit in the Printer Driver” on page 204 & “Cleaning the Paper Path for Paper Feeding Problems” on page 136 & “Setting the Paper Size and Paper Type for Each Paper Source” on page 47 & “Printer Settings” on page 33 Original Does Not Feed in the ADF ❏ Use originals supported by the ADF.
❏ Load originals in the correct direction, and slide the edge guides against the edges of the originals. ❏ Clean the inside of the ADF. ❏ Do not load above the line just under the d symbol inside the edge guide. 166