User's Guide Solving Problems & “Cannot Send or Receive Faxes” on page 177 & “Memory Full Error Occurs” on page 180 Memory Full Error Occurs ❏ If the printer has been set to save received faxes in the inbox, delete faxes you have already read from the inbox. ❏ If the printer has been set to save received faxes on a computer, turn on the computer that is set to save the faxes. Once the faxes are saved in the computer, they are deleted from the printer's memory. ❏ If the printer has been set to save received faxes on a memory device, connect the device, in which you have created a folder to save faxes, to the printer.
Once the faxes are saved in the device, they are deleted from the printer's memory. Make sure that the device has enough available memory and is not write protected. ❏ Even though the memory is full, you can send a monochrome fax by using the Direct Send feature. Or divide your originals into two or more to send them in several batches. ❏ If the printer cannot print a received fax due to a printer error, such as a paper jam, the memory full error may occur. Clear the printer problem, and then contact the sender and ask them to send the fax again.
Related Information & “Saving Received Faxes in the Inbox” on page 105 & “Saving Received Faxes on a Computer” on page 107 & “Saving Received Faxes in an External Memory Device” on page 106 & “Sending Many Pages of a Monochrome Document (Direct Send)” on page 101 & “Removing Jammed Paper” on page 157 & “Replacing Ink Cartridges” on page 117 Sent Fax Quality Is Poor ❏ Clean the scanner glass. ❏ Clean the ADF. ❏ Change the Resolution setting on the control panel. If your originals contain both text and photos, select Photo . ❏ Change the Density setting on the control panel.
❏ If you are not sure about the capabilities of the recipient fax machine, enable the Direct Send feature or select Fine as the Resolution setting. If you select Super Fine or Ultra Fine for a monochrome fax, and send the fax without using the Direct Send feature, the printer may automatically lower the resolution. ❏ Enable the ECM setting on the control panel. Related Information & “Fax Mode” on page 26 & “Fax Settings” on page 34 & “Cleaning the Scanner Glass” on page 139 & “Cleaning the ADF” on page 137 180