Chapter 2: Installation 2-8 Jumper Settings Explanation of Jumpers To modify the operation of the mother board, jumpers can be used to choose between optional settings. Jumpers cre ate shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the mother board layout pages for jumper locations. Connector Pins 3 2 1 Jumper Cap 3 2 1 Setting Pin 1-2 short Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. CMOS Clear JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads to prevent accidental clearing of CMOS.
To clear CMOS, use a metal object such as a small screwdriver to touch both pads at the same time to short the connec tion. Always remove the AC power cord from the system before clearing CMOS. Note: Be sure to remove the onboard CMOS Battery before you short JBT1 to clear CMOS. JBT1 contact pads 2-37