Supermicro X10DRT-B+ — Supermicro X10DRT-B+ Motherboard User's Manual PDF (Rev 1.0c)

Chapter 2: Installation VGA Enable Jumper JPG1 allows the user to enable or disable the onboard VGA connector. The default setting is 1-2 to enable the connection. See the table on the right for jumper settings. BMC Enable Jumper JPB1 allows you to enable the onboard BMC (Baseboard Management) Controller) to provide IPMI 2.0/KVM support on the motherboard. Be sure to remove the power cord before closing pins 2-3 to disable the BMC. See the table on the right for jumper settings. UID_LED1 UID SW VGA JVRM1 JVRM2 1. VGA Enable 2. BMC Enable CPU1 SLOT1 PCI-E 3.0 X16 BMC_HB_LED1 IPMI_LAN JBAT1 USB0/1 (3.0) Battery LE6 1 2 JPG1 JPB1 JWD1 FAN3 3 4 BMC FLASH BIOS FAN4 SIOM:

CPU1 PCI-E 3.0 X16 2 1 JBT1 JPME2 C612 TPM/Port80 JTPM1 BIOS LICENSE IPMI CODE CPU2 SLOT2 PCI-E 3.0 X16 CPU1 PCI-E 3.0 X4 SXB2 SXB1 JF2 JF1 J* S-SATA3 X10DRT-B+ Rev.

1.01 JSD1 P1-DIMMA1 P1-DIMMA2 P1-DIMMA3 P1-DIMMB2 P1-DIMMB1 P1-DIMMB3 P1-DIMMD3 P1-DIMMD1 P1-DIMMD2 P1-DIMMC3 P1-DIMMC1 P1-DIMMC2 CPU1 PCI-E 3.0 X4 I-SATA0~5 S-SATA0~2 CPU1 1 CPU2 PCI-E 3.0 X24 OPEN 1st 1 1 CPU2 1 BAR CODE P2-DIMMG1 P2-DIMMG2 P2-DIMMG3 P2-DIMMH1 P2-DIMMH2 P2-DIMMH3 P2-DIMMF3 P2-DIMMF1 P2-DIMMF2 P2-DIMME3 P2-DIMME2 P2-DIMME1 2-39 VGA Enable Jumper Settings Jumper Setting Definition 1-2 Enabled (Default) 2-3 Disabled BMC Enable Jumper Settings Jumper Setting Definition Pins 1-2 BMC Enable (Default) Pins 2-3 BMC Disable