Supermicro X10DRT-B+ — Supermicro X10DRT-B+ Motherboard User's Manual PDF (Rev 1.0c)

Chapter 4: AMI BIOS *If the item above "Configure sSATA as" is set to AHCI, the following items will display: sSATA Support Aggressive Link Power Management When this item is set to Enabled, the sSATA AHCI controller manages the power usage of the SATA link. The controller will put the link to a low power state when the I/O is inactive for an extended period of time, and the power state will return to normal when the I/O becomes active. The options are Disabled and Enabled. sSATA Port 0~ Port 3 This item displays the information detected on the installed on the sSATA port. specified by the user.

Model number of drive and capacity Software Preserve Support sSATA Port 0~ Port 3 Select Enabled to enable an sSATA port specified by the user. The options are Disabled and Enabled . sSATA Port 0 ~ Port 3 Hot Plug Select Enabled to enable hot-plugging support for a port specified by the user, which will allow the user to replace a sSATA disk drive installed on this port without shutting down the system. The options are Enabled and Disabled. sSATA Port 0 ~ Port 3 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE­ SET initialization to the device. The options are Enabled and Disabled .

Port 0 ~ Port 3 sSATA Device Type Use this item to specify if the sSATA port specified by the user should be con­ nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. *If the item above "Configure sSATA as" is set to IDE, the following items will display: sSATA Port 0~ Port 3 This item indicates that an sSATA port specified by the user is not installed or not detected. 4-29