Chapter 4: AMI BIOS sSATA Port 0 ~ Port 3 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE SET initialization to the device. The options are Enabled and Disabled . Port 0 ~ Port 3 sSATA Device Type Use this item to specify if the sSATA port specified by the user should be con nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. Server ME (Management Engine) Configuration This feature displays the following system ME configuration settings.
General ME Configuration Operational Firmware Version ME Firmware Type Recovery Firmware Version ME Firmware Features ME Firmware Status #1 ME Firmware Status #2 Current State Error Code PCIe/PCI/PnP Configuration The following PCI information will be displayed: PCI Bus Driver Version PCI Devices Common Settings: PCI Latency Timer Use this item to configure the PCI latency timer for a device installed on a PCI bus. Select 32 to set the PCI latency timer to 32 PCI clock cycles. The options are 32 , 64, 96, 128, 160, 192, 224 and 248 (PCI Bus Clocks). 4-31