X8DTG-QF+ User's Manual 2-2 Motherboard Installation All motherboards have standard mounting holes to fi t different types of chassis. Make sure that the locations of all the mounting holes for both motherboard and chassis match. Although a chassis may have both plastic and metal mounting fasteners, metal ones are highly recommended because they ground the mother- board to the chassis. Make sure that the metal standoffs click in or are screwed in tightly. Then use a screwdriver to secure the motherboard onto the motherboard tray. Note : Some components are very close to the mounting holes.
Please take precautionary measures to prevent damage to these components when installing the motherboard to the chassis. Locations of Mounting Holes Tools Needed 1. Phillips Screwdriver 2. Eight (8) Pan head #6 screws Installation Instructions Install the IO shield into the chassis. 1. Locate the mounting holes (8) on the moth- 2. erboard and the matching mounting holes on the chassis. Align the mounting holes on the motherboard with their correspond- ing mounting holes on the chassis. Locate the standoff locator hole on the 3. motherboard and the standoff locator on chassis. Install standoffs on the chassis as needed. 4.
Install the motherboard into the chassis carefully to avoid damage to mother- 5. board components. Warning : To avoid damaging the motherboard and its components, please do not apply any force greater than 8 lb/sq.in (8 lbs. per square inch) when installing a screw into a mounting hole. Insert a Pan head #6 screw into a mounting hole on the motherboard and its 6. matching mounting hole on the chassis, using a Phillips screwdriver. Repeat Step 4 to insert #6 screws to all mounting holes, making sure that the 7. motherboard is securely placed on the chassis. 2-2 X8DTG-QF+ Rev. 1.10 Standoff (Locator)