Supermicro X8DTG-QF+ — X8DTG-QF+ 1.0.indb

Chapter 2: Installation 2-6 Connecting Cables Power Connectors Three SMC-proprietary power connectors (JPW1/ JPW2/JPW9) provides main power to the mother- board. Special cables are needed for these con- nectors. Power Connectors JPW3/4 are used to provide power to the PCI-E cards installed in Slots SXB3/4. Connect your power cables to JPW5, JPW8, JPW11 to provide power to the addon card installed on Slot SXB1. For the addon card installed on Slot SXB2 to function properly, con- nect JPW7 to the power supply. The 8-pin power connector, located at JPW6, is used for SATA devices located on the midplane.

Also, be sure to use a standard SATA power cable to convert the 4-pin HDD power connector located at JPW10 for additional SATA drive use. See the layout below for power connector locations. JUSBRJ45 USB0/1 A. JPW1: SMC-Proprietary Main PWR COM1 J_UID _OW IPMI LAN JPB1 B. JPW2: SMC-Proprietary Main PWR C. JPW9: SMC-Proprietary Main PWR SXB5: PCI-E 2.0x8 + 1.0 x4+x4 SXB6: D. JPW3: 8-Pin PWR for PCI-E GPU card in Slot PCI-E 2.0x8 (in x 16 Slot) JI2C4 JI2C3 A JPW10 K SXB4 X8DTG-QF+ Rev. 1.10 E. JPW4: 8-Pin PWR for PCI-E GPU card in Slot SXB3 F. JPW5: 8-Pin PWR for PCI-E GPU card in Slot SXB1 G. JPW11: 8-Pin PWR for PCI-E GPU card in Slot SXB1 H. JPW6: 8-Pin PWR used for SATA Midplane I. JPW7:

8-Pin PWR used for SXB2 A A JPW1 A J. JPW8: 8-Pin PWR used for SXB1 JPW11 G Fan 11 Fan12 K. JPW10: 4-Pin PWR used for additional SATA JPCIE1 SXB1: F C drive PCIE 2.0x16 B SXB2: PCIE 2.0x16 D E I J A A A 1 LE1 JL1 H 2-19 12V 8-pin PWR Connector Pin Defi nitions Pins Defi nition 1 through 3 +12V 4 through 8 Ground 4-pin HDD PWR Connector (JPW10) Pin Defi nitions Pins Defi nition 1 +12V 2 Ground 3 Ground 4 +5V JPW2 SXB3:PCIE 2.0x16 SXB4: PCIE 2.0X16 JPW9