Chapter 2: Installation CMOS Clear JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads to prevent the accidental clearing of CMOS. To clear CMOS, use a metal object such as a small screwdriver to touch both pads at the same time to short the connection. Always remove the AC power cord from the system before clear- ing CMOS. Note: For an ATX power supply, you must completely shut down the system, remove the AC power cord and then short JBT1 to clear CMOS. Also, be sure to remove the onboard CMOS Battery before you short JBT1 to clear CMOS.
Watch Dog Enable/Disable Watch Dog (JWD) is a system monitor that can re- boot the system when a software application hangs. Close Pins 1-2 to reset the system if an application hangs. Close Pins 2-3 to generate a non-maskable interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in the BIOS. JUSBRJ45 USB0/1 A. CMOS Clear COM1 J_UID _OW IPMI LAN B. WD SXB5: PCI-E 2.0x8 + 1.0 x4+x4 SXB6: PCI-E 2.0x8 (in x 16 Slot) JI2C4 JI2C3 A JPW11 JPCIE1 PCIE 2.0x16 SXB1: SXB2: PCIE 2.0x16 1 LE1 JL1 2-25 Watch Dog Jumper Settings Jumper Defi nition Pins 1-2 Reset (default) Pins 2-3 NMI Open Disabled JPB1 JPW10 B X8DTG-QF+ Rev.
1.10 JPW1 A A A Fan12Fan 11 JPW9 SXB3:PCIE JPW2 2.0x16 SXB4: A A A PCIE 2.0X16 JPW2 SXB3:PCIE 2.0x16 SXB4: PCIE 2.0X16 JPW9