Omnidirectional Wheel * Clean it as needed. Filter * It is recommended to clean every two weeks. 1. Flip the robot vacuum over and pull out the omnidirectional wheel. 2. Remove hair, dirt, and other debris from the wheel and axle. 3. Reinsert the wheel and press it firmly back into place. Wheel 1. Remove the filter from the filter clip as illustrated. Axle 2. Rinse and gently tap the edges of the filter to remove any dust and debris until it is clean. Notes: · A small screwdriver or other pry tool can be used to gently pop out and remove the wheel. · The wheel can be cleaned with water and reinstalled after drying. Dust Compartment * It is recommended to clean every week. 1.
Open the cover of the robot vacuum, and press the dust compartment clip to remove the dust compartment upwards. 2. Open the dust compartment cover, and empty out the contents. Note: Do not attempt to clean the filter with a brush or finger. 3. Open the dust compartment cover, fill the dust compartment with clean water and close the dust compartment cover. Shake the dust compartment from side to side and then pour the dirty water out of the compartment. 4. Place the dust compartment and filter aside to dry before reinstallation. emptying its contents. Note: To prevent the filter from becoming clogged, lightly tap the dust compartment when · Only use clean water to clean the filter.
Do not use detergent. · Thoroughly dry the dust compartment and the filter before putting them back. 12 :