Line 1 SUCCESS: interface loop 100 Line 2 SUCCESS: ip address 10.10.10.10 255.255.255.255 Line 3 SUCCESS: end *** Executing show ip interface brief *** Interface IP-Address OK? Method Status Protocol GigabitEthernet0/0/0 unassigned YES unset down down GigabitEthernet0/0/1 unassigned YES unset down down GigabitEthernet0/0/2 unassigned YES unset down down GigabitEthernet0/0/3 192.168.1.246 YES DHCP up up GigabitEthernet0 192.168.1.246 YES DHCP up up Loopback100 10.10.10.10 YES TFTP up up *** ZTP Day0 Python Script Execution Complete *** Press RETURN to get started! The day zero provisioning is complete, and the Cisco IOS prompt is accessible.
Boot Log for Cisco Catalyst 9000 Series Switches The following sections display sample Zero-Touch Provisioning boot logs. These logs shows that Guest Shell is successfully enabled, the Python script is downloaded to the Guest Shell, and the Guest Shell executes the downloaded Python script and configures the device for Day Zero. = % Checking backup nvram % No config present. Using default config FIPS: Flash Key Check : Begin FIPS: Flash Key Check : End, Not Found, FIPS Mode Not Enabled ! message indicates that the startup configuration is absent on the device.
This is the first indication that the Day Zero work flow is going to start.> Cisco IOS XE Everest 16.6.x to Cisco IOS XE Fuji 16.8.x The following example shows the sample boot logs before the .py script is run: Press RETURN to get started! The process for the command is not responding or is otherwise unavailable The process for the command is not responding or is otherwise unavailable The process for the command is not responding or is otherwise unavailable The process for the command is not responding or is otherwise unavailable Zero-Touch Provisioning Boot Log for Cisco Catalyst 9000 Series Switches Zero-Touch Provisioning 14