Press RETURN to get started! Cisco IOS XE Amsterdam 17.2.x and Later Releases This following example shows the sample boot logs before the .py script is run: --- System Configuration Dialog --- Would you like to enter the initial configuration dialog? [yes/no]: Acquired IPv4 address 10.127.128.8 on Interface GigabitEthernet0/0 Received following DHCPv4 options: bootfile : test.py tftp-server-ip : 159.14.27.2 OK to enter CLI now... pnp-discovery can be monitored without entering enable mode Entering enable mode will stop pnp-discovery Attempting bootfile tftp://159.14.27.2/test.py day0guestshell activated successfully Current state is:
ACTIVATED day0guestshell started successfully Current state is: RUNNING Guestshell enabled successfully *** Sample ZTP Day0 Python Script *** ... *** ZTP Day0 Python Script Execution Complete *** Guestshell destroyed successfully The following example shows how to configure the device for Day Zero provisioning: Both links down, not waiting for other switches Switch number is 1 Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec.
52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. Cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco IOS Software [Amsterdam], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 17.2.1, Zero-Touch Provisioning Boot Log for Cisco Catalyst 9000 Series Switches Zero-Touch Provisioning 33