ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

С8С CU325 Fig.4-3. Machine main parts and controls 4.4 SPINDLE SPEED SELECT Universal lathes C8C and CU325 are available as either 12- speeds when single- speed drive motor is installed or 24-speeds when double-speed drive motor is installed. Fig. 4-6 and Fig. 4-7 show the spindle speeds of rotation. Handles 15, 24 and 26 serve to select spindle speed following the instructions on plates Fig.4-6 and Fig. 4-7. For machine provided by double-speed drive motor it is also necessary to observe the position of drive motor speed select switch. Warning: Spindle speed change must ONLY be performed after spindle stop.

Any attempt to change the spindle speed when it is running leads to a serious damage of the gearbox and voids the guarantee. 4.5 FEED DRIVE The machine feed drive and threading mechanism is consists of: Left hand and right hand thread mechanism: it is located in the gearbox and is controlled by handle 18, Fig.4-1; C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 27/67