ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

Fig.4-8 The carriage travel when threading is effected by the lead screw and apron half- nut . By handle 31, Fig.4-2 the half-nut engagement with lead screw is affected. Between the handle for half-nut engagement and the handle for automatic feed is provided a protection device is provided so that one only to be effective at a moment. When the half-nut is engaged the carriage control is by handle 22, Fig.4-1. 4.6 SETTING THE MACHINE FOR THREAD CUTTING The machine can be set for cutting metric, inch, module and diameter pitch threads, as indicated on the plate located on machine front. Procedure:

Set the speed and speed range by handle 24, 25 and 26 Fig.4-1 in compliance with the plate of threads; By handle 18, Fig.4-1 set either left hand thread or right hand thread; In compliance with the plate for threads arrange the quadrant 11, Fig.4-3 change over gears ; By handle 28, Fig.41 set the multiplication mechanism in compliance with the plate for threads (1; 2; 3; 4; 5); By handle 29, Fig.41 set the selection mechanism in compliance with the plate for threads (1; 2; 3; 4); By handle 30, Fig.4-1 set the thread type; By handle 31, Fig.4-2 engage the half-nut to screw; Besides above threads additional threads are also available , Fig.4-11 and Fig.4-12 and can be set same way as described above.

C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 29/67