HOME 30. Loosen and remove cross member fasteners holding the bottom of the radiator/oil cooler assembly on both sides. sm01985 31. Put radiator/oil cooler assembly forward at the bottom. Separate oil lines from crankcase (oil in) and oil filter (oil out) fittings. See 5.7 OIL LINE FITTINGS . 32. Remove radiator/oil cooler assembly. See 5.8 RADIATOR AND OIL COOLER . 2 33. Remove engine coolant pipes. See 5.6 COOLANT PIPES AND HOSES . 1 NOTE Dispose of antifreeze in accordance with local regulations. 34. Remove drive sprocket cover. 2 NOTE Remove debris deflector/belt guard, if required, for clearance. See 2.36 BELT GUARD AND DEBRIS DEFLECTOR . 35. See Figure 2-12 .
Loosen retaining bolts holding drive sprocket to sprocket mounting flange. NOTE Do not remove the output shaft flange nut (4). 1. Drain plug 2. Cover fastener and washer 36. Remove snap ring and loosen rear wheel axle nut. Move wheel forward and slip belt off wheel sprocket. Pull belt off of drive sprocket. Figure 2-10. Radiator Cover Left Side (typical) 37. See Figure 2-12 . Remove retaining bolts from drive sprocket. Discard bolts. 38. and remove sprocket. 39. clutch actuator. See ATOR . 40. SOLENOID . 41. Remove nuts holding starter solenoid to frame and pull solenoid off of frame studs. See 7.9 STARTER SOLENOID . Figure 2-11.
Front Cylinder Coolant Drain Plug NOTE To avoid strain on solenoid green and black wire leads, locate connector under left side cover and press on release square to separate connector halves. 2009 VRSC Service: Chassis 2-17 it spoke pattern of mounting . clutch actuator cover and sec 2.14 SECONDARY CLUTCH flange ondary ACTU- sm00616