HOME is04675 is04677 3 2 3 1 1 2 1. Sprocket 2. Bearing inner race 3. Driver 1. Sprocket 2. Bearing outer race 3. Driver Figure 2-81. Remove Compensator Sprocket Bearing Figure 2-83. Install Compensator Sprocket Bearing 9. Obtain the Rear Wheel Compensator Sprocket Bearing Remover/Installer (HD-48921). 15. Inspect compensator cushion for missing chunks or excessive debris beyond normal wear marks. Replace if necessary. 10. See Figure 2-82 . Position Base BASE (Part No. HD-48921- 2) on deck of arbor press with the small OD topside. Slide Sleeve SLEEVE (Part No. HD-48921-4) over the pin base. 16. Inspect brake disc. Replace disc if warped or badly scored.
Measure disc thickness for excessive wear. Minimum acceptable thickness is stamped on side of disc. 11. Verify that sprocket bearing bore is clean and dry. 12. See Figure 2-83 result in death or serious injury. (00111a) 13. makes firm contact with counterbore in sprocket. Disas- semble tool. 18. Inspect brake pads, calipers, and brake lines. Replace pads and service calipers and brake lines as required. See 1.11 BRAKE PADS AND DISCS . 14. Turn sprocket over and verify that bearing is fully seated. 2.29 TIRES . new screws. Thread in 2.29 TIRES . -83. With the outboard side facing u r sleeve until it rests on base. Slide b ith the extended inner race down.
Slid p, slide 2.27 SEALED WHEEL BEARINGS earing e large sleeve Always replace brake pads in complete sets for correct earing and safe brake operation. Improper brake operation could DRIVER (Part No. HD-48921-3) over s made with outer race of bearing. under ram and apply pressure until b is04676 2 1 1. Base 2. Sleeve lbs). 4. Verify that wheel and tire ar 2.28 DISC RIM RUNOUT and leeve Set for Bearing Installation 5. After wheel is balanced, app LUBRICANT to entire surface bowl) bearing race only. e: Chassis Figure 2-82. Base and S 2-68 2009 VRSC Servic