HOME 2.27 SEALED WHEEL BEARINGS GENERAL Inspection for lateral end play, removal, and installation proced- ures for sealed wheel bearings are the same for both the front wheel and the rear wheel. sm03111 10 9 8 INSPECTION: LATERAL END PLAY 7 6 12 1. Block motorcycle underneath frame so wheel is raised off ground. 1 NOTE If ABS equipped, keep magnetic base dial indicator as far away from wheel speed sensor and ABS encoder bearing as pos- sible, or damage will occur. 2 11 5 4 2. See Figure 2-85 . Mount a magnetic base dial indicator to brake disc with dial's contact point on end of axle. 3 13 remove wheel and replace both wheel bearings.
REMOVAL TOOL NAME PART NUMBER WHEEL BEARING INSTALLER/REMOVER HD-44060 and 2.23 FRONT Figure sm03110 NO. Figure 2-85. Measuring Lateral End Play (Front Wheel) (typical) 3. To check for lateral end play, turn wheel through several rotations, then move wheel side to side. a. If end play is less than service wear limit of 0.051 mm (.002 in.), bearing passes inspection. b. If end play exceeds service wear limit or feels rough, 2-86. HD-44060 Wheel Bearing Tools (See Table) Table 2-10. HD-44060 Wheel Bearing Tools DESCRIPTION PART NO. 1 Bridge HD-44060-5 2 Steel ball 12547 3 Forcing screw HD-44060-4 4 Nut 10210 5 Wa sher 12004 6 Bearing RS25100-200 7 Lubricant J-23444A 8 Collet, 3/4 in.
HD-44060-3 9 Collet, 1.0 in. HD-44060-7 10 Pilot, 1.0 in. HD-44060-8 11 Pilot, 3/4 in. HD-44060-6 12 Support plate HD-44060-1 13 Threaded rod 280856 Parts 1-7 common to removal/installation. Parts 8-9 used for removal only. Parts 10-13 used for installation only. 1. Remove wheel. See 2.26 REA WHEEL. 2009 VR R WHEEL SC Servic