HOME 5. Tighten stabilizer link to frame tab fastener (4) to 34-41 Nm (25-30 ft-lbs). sm03122 NOTE If installing the stabilizer link causes interference between the rear tire and fender mounting hardware or the lower left crankcase and frame rail, the stabilizer link can be shorten or lengthened a short distance while fastened to frame tab and crankcase. Rotate the adjusting nut and rod (no more than two turns) to provide clearance. It is recommended to never turn the adjusting nut and rod more than two turns in or out with the stabilizer link fastened to the crankcase and the frame tab. 4 6. Tighten lock nuts on stabilizer link ball ends (1) to 34-41 Nm (25-30 ft-lbs). 2 5 3 1 1 1.
Ball ends 2. Lock nuts 3. Adjusting nut 4. Stabilizer link to frame tab fastener @ 34-41 Nm (25-30 ft-lbs) 5. Frame tab Figure 2-98. Engine Stabilizer Link 2009 VRSC Service: Chassis 2-79