HOME Right Side Bearing Installation 1. See Figure 2-158 . Load new bushing onto bushing remover/installer and insert into outer side of right swingarm. sm03199 sm03196 Figure 2-159. Insert Lock Ring 10. See Figure 2-160 . Verify that lock ring has completely seated in swingarm. 2. Remover/Installer. 3. with cupped side facing swingarm. 4. Install bearing and nut. 5. Tighten nut and forcing screw finger tight. NOTE 6. housing. 7. Loosen and remove tool. Figure 2-160. Lock Ring Fully Seated NOTE When installing bushing, tighten tool and begin installation process, stop and back tool off after a few turns and view how far the bushing has been pressed into the swing arm assembly.
Bushing should be evenly centered between beveled edges of swingarm casting. INSTALLATION TOOL NAME PART NUMBER 8. Check position of bushing in swingarm housing. SWINGARM GUIDE HD-47176 9. See Figure 2-159 . Slowly spiral lock ring into recess in swingarm using a clockwise turning motion. 1. See Figure 2-161 . Install SWINGARM GUIDE (Part No. HD-47176) into pivot shaft cavity in frame. 2009 VRSC Service: Chassis 2-109 e Bushing (typical) small hole in Bushing uter left arm of swingarm m. ger tight. d of the tool without the d with bearing installed. ired position in swingarm sm03200