HOME 2. See Figure 2-175 . Remove cotter pin (3) from clevis pin (2). sm02023 NOTE Wear gloves and protective eyeglasses (or face shield) when performing the following procedure. The jiffy stand spring ten- sion could cause the spring, attached components and/or hand tools to fly outward. 3. With leg in the retracted position, detach spring (6) from jiffy stand leg (5), and anchor (7). 4. Remove clevis pin (2) by gently tapping on pin from bottom to drive pin up through mounting bracket. 5. Pull out jiffy stand leg and remove upper and lower bush- ings. 6. Loosen and remove the anchor (7). 7. Remove rubber bumper (1), if necessary. Figure 2-174.
Bushings in Retracted Position NOTE Jiffy stand brackets can be replaced by replacing the left lower frame rail. See 2.3 FRAME AND LOWER FRAME RAILS . Figure 2-175. Jiffy Stand Components (typical) 2009 VRSC Service: Chassis 2-117 INSTALLATION 1. See Figure 2-175. Apply LOCTITE 243 (blue) to anchor (7). Install and tighten anchor to 7-9 Nm (62-79 in-lbs). 2. Apply LOCTITE AEROSOL ANTI-SEIZE to both bushings (4) and install bushings in position for a retracted leg. 3. Orient leg retracted in mounting bracket, and install new clevis pin (2) through the upper bushing (4), leg (5), and lower bushing (4). 4. Install new cotter pin (3). 5.
Attach spring (6) to the anchor and to jiffy stand leg (5). When properly installed, spring open hook on anchor faces outward and open hook on jiffy stand leg faces down when jiffy stand leg is extended. 6. Replace rubber bumper (1) if required. 7. Check that jiffy stand operates correctly before supporting the weight of the motorcycle on the leg. sm02030 2 1 3 4 5 4 6 7 1. Rubber bumper 2. Clevis pin 3. Cotter pin 4. Bushings (2) 5. Leg 6. Spring 7. Anchor