HOME 4. See Figure 3-36 . Install primary chain fixed tensioner. Note the flat in the chain tensioner bore and the flat on the mounting shaft in the case. sm00987 sm04537 Figure 3-33.Top Dead Center Positioning Tool Figure 3-36. Primary Chain Fixed Tensioner 5. Guide the chain over the edge of the primary cam chain fixed tensioner. sm00980 6. See Figure 3-37 . Retract the chain tensioner and install PRIMARY CAM CHAIN TENSIONER RETAINER (Part No. HD-45326). 7. Verify crankshaft is still at TDC and confirm the position of the timing marks. 8. See Figure 3-38 . Install primary chain hydraulic tensioner fastener. Tighten to 9.7 Nm (86 in-lbs ). 9. See Figure 3-39 .
Install triple sprocket fastener. Hold crankshaft from clutch side and tighten to 23 Nm (17 ft- lbs). 10. See Figure 3-40 . Install fastener on primary chain fixed Figure 3-34. Water Pump Shaft tensioner. Tighten to 9.7 Nm (86 in-lbs ). 11. See Figure 3-41 . Install needle roller bearing, ball clutch gear, and thrust washer on crankshaft. sm00983 sm00945 Figure 3-35.Triple Gear Timing Marks Figure 3-37. Primary Chain Tensioner Retainer 2009 VRSC Service: Engine 3-25 Figure 3-35.Tr nsioner Retainer Service: Engine 3-25