HOME 1.27 HEADLAMP ALIGNMENT HEADLAMP ALIGNMENT om00671 The automatic-on headlamp feature provides increased visibility of the rider to other motorists. Be sure headlamp is on at all times. Poor visibility of rider to other motorists can result in death or serious injury. (00030b) 4 5 2 NOTE Vehicles with multiple beam headlamps that are individually aimed should be adjusted so both lamps converge into one pattern. 1 3 1. Verify that front and rear tire inflation pressures are correct and that suspension is adjusted to the weight of the prin- cipal rider. See 1.13 TIRES AND WHEELS . 2. Fill fuel tank or add ballast to equal the weight of the fuel needed. 1. Perpendicular line 2.
Vertical line 3. 7.6 meters (25 feet) 4. High beam bulb centerline 5. Horizontal line 53.3 mm (2.1 in.) lower than bulb centerline NOTE See Figure 1-99 . To aid in properly placing the motorcycle, a perpendicular line (1) can be drawn on the floor. For best res- ults, choose an area with minimum light. 3. See Figure 1-99 . Draw a vertical line (2) on the wall. Figure 1-99. Headlamp Alignment: VRSC Models 4. Position motorcycle so that front axle is 7.6 meters (25 feet) from wall. NOTE NOTE As the weight of the rider will compress the suspension slightly, have a person whose weight is approximately the same as that of the principal rider sit on the motorcycle.
As the weight of the rider will compress the suspension slightly, have a person whose weight is approximately the same as that of the principal rider sit on the motorcycle. 5. With the vehicle laden and upright, point the front wheel straight forward at wall and measure the distance (4) from the floor to the center of the HIGH BEAM bulb. 7. See Figure 1-99 . Verify headlamp alignment. Turn the ignition switch to IGNITION and set the headlamp switch to HIGH beam. 6. Draw a horizontal line (5) through the vertical line on the wall that is 53.3 mm (2.1 in.) lower than the measured bulb centerline. a.
The center of the hot spot (brightest area of light beam) should be centered where the two lines inter- sect. b. Adjust headlamp alignment if necessary. HEADLAMP ADJUSTMENT 1. See Figure 1-100 (VRSCAW/VRSCF) or Figure 1-101 (VRSCDX). Loosen fasteners slightly so headlamp is still snug. 2. Move headlamp assembly to adjust vertical alignment. 3. Tighten fasteners. For VRSCAW and VRSCF models, tighten to 4.5-7.5 Nm (40-66 in-lbs ). For VRSCDX model, tighten to 31-41 Nm (23-30 ft-lbs). 2009 VRSC Service: Maintenance 1-65