80 F2B ENGINE T RAKKER E URO 4/5 541210 Camshaft 541211 Checking cam lift and pin alignment Figure 129 47506 Place the camshaft (4) on the tailstock (1) and check cam lift (3) using a centesimal gauge (2); values are shown in table on page 19. Figure 130 47507 When thecamshaft (4) is on the tailstock (1),check alignment ofsupporting pin (3) using a centesimal gauge (2); it must not exceed 0.030 mm. If misalignment exceeds this value, replace the shaft. Figure 131 1 47505 In order to check installation clearance, measure bush inner diameter and camshaft pin (1) diameter;the real clearance is obtained by their difference.
If clearance exceeds 0.150 mm, replace bushes and, if necessary, the camshaft. Base q November 2006 Print 603.93.641