98 F2B ENGINE T RAKKER E URO 4/5 PRINT603.93. 641 Base q November 2006 Print 603.93.641 Figure 197 Fit the rocker cover (1). Fit the blow-by case (7) and its screws (8) to the prescribed tor Install the filter (5) and the gaske 84377 gasket and then tighten the que. ts (4 and 6). is unidirectional, therefore ith the two sight supports re. n hole and suction ducts. fastening screws (2) to the ITE 5970 IVECO No. w-by case (7) surface of .T.O. according to the he following figure. 84392 VECO No. 2995644 on the 2) of 1.5 , 0.5 as shown 0.2 (1) within 10 from sealer Figure 199 47573 Rotate the engine, then fit the oil suction strainer.
Place gasket (4) on oil sump (1), then position frame (3) and fit the sump onto the engine base by tightening screws (2) to the specified torque. ENGINE COMPLETION Make the engine complete by either fitting or disconnecting the items below:
- power take-off (P.T.O.), if any, and its respective pipes; - air compressor complete with power steering pump; - fuel pump; - full fuel filter support and pipes; - EDC control unit; - intake manifold; - preheating resistor; - heat exchanger; - oil filter (lubricate the gasket); - exhaust manifold; - turboblower and its respective water and oil pipes; - damper flywheel and pulley; - thermostat unit; - belt stretcher, water pump and alternator; - electromagnetic joint; - drive belt; - belt stretcher (if any), air-conditioner compressor; - drive belt; - oil level dipstick; - electric connections and sensors.
NOTEThe fittings of the cooling water and lubricating oil pipes of the turbocharger have to be tightened to a torque of: - 35 5 Nm, water pipe fittings; - 55 5 Nm, oil pipe female fitting; - 20-25 Nm, oil pipe male fitting. NOTE The filter (5) operation it must be assembled w as illustrated in the figu Thoroughly clean cover (3) drai Fit the cover (3) and tighten the prescribed torque. NOTE Apply silicone LOCT 29955644 on the blo engines fitted with P procedure described in t Figure 198 Apply silicone LOCTITE 5970 I blow-by case and form a string ( in the figure. NOTE Fit the blow-by case application.