Iveco — 603.93.641-3Cp

240 F3B ENGINE T RAKKER E URO 4/5  Figure 246 Lubricate bushing ( actuator (1) to turbocompressor Connect tie rod (3) to lever (8). Mount new ring (4), mount Screw up screws (2) turbocompressor (7). Tighten screws (2 and 6) at Checking actuator travel Figure 247 Check travel X of tie rod (2) follows. Measure distance X1 between actuator eyelet (4). Apply, to fitting of actuator modulating it,from 0 of travel. Measure again the distance cross-axis of eyelet (4) Travel X of tie rod (2) of actuator subtraction X = X2-X1 and 11.5 0.5 mm. Base q November 2006 Print 603.93.641 106229 d (3) and pin ( ) of lever (8) GREASE type and reconnect or (7) operating as follows. ).

k (5) and screw up screw (6). ecuring actuator (1) to Nm torque. el 106230 of actuator (1) operating as actuator (1) and cross-axis of piping (3) for compressed air gulator. By using the pressure or (1) compressed air slowly ntil lever (5) is takento its end between actuator (1) and sion X2. ator (1) is given by following must result to be equal to Cleaning turbine body Figure 248 106231 Mark mounting position of clamp (2) on central body (1). On threading and nut (4), apply antioxidant spray lubricant and, operating on nut (4), loosen clamp (2). Slightly rotate clamp (2) using pliers (5). Mark mounting position of turbine body (3) on central body (1).

Figure 249 106232 By a copper hammer, beat on two opposite points (~180º) on turbine body (2) to separate turbine body from central body (1). NOTE In operation,take particular care to avoid damaging turbine rotor. After dismounting turbine body, check variable geometry movement as described in relating chapter; where improvement in movement is not found with respect to previous check, replace turbocompressor.