SCANNER hp Color 9850mfp 2.7 Reinstalling the scanner wire A. Procedure 1. Move the V-mirror unit [1] to the paper exit side, and pass the optical positioning jig [2] through [1] the V-mirror unit [1] from the front side. Note: • Be careful not to damage the mirror with the jig. • When reinstalling the scanner wire, be sure to fasten the V-mirror with the optical position- ing jig. III DIS./ASSEMBLY [2] 2. Drop into the fitting hole of the drive pulley [4] a metal bead [3] provided at the center of each of [5] [6] [1] the scanner wires F [1] and R [2], and starting from this hole, wind the scanner wire 2.5 turns [4] [5] outwards and 3.5 turns [6] inwards. [7] [3] [8] Note:
• For the scanner wires F and R, common wires are used. [8] • Be sure to wind each of scanner wires so that the wire terminal is on the outside and the metal bead [7] on the inside. [4] • Be sure to wind each of scanner wires so that both ends of the wire come out under the [2] [5] [6] • Be sure to wind each of the scanner wires drive pulley. [4] closely around the drive pully with no wire running on another wire. [7] [3] 3. After winding the scanner wires F and R, be sure to fasten each wire end with a tape [8] so that it will not come off. 3-22