PROCESS UNIT hp Color 9850mfp 4.17 Replacing the belt separation claw solenoid A. Periodically replaced parts/cycle • Developer: Every 1,500,000 copies B. Procedure 1. Remove the transfer belt unit. (See " 4.5 Remov- ing and reinstalling the transfer belt unit .") 2. Remove the screw [1] and then remove the 3. Remove the relay connector [3]. solenoid lever [2]. 4. Remove the screw [4] and release the cable [6] from the cable clamp [5]. 5. Remove 2 screws [7] and then remove the SD1 (belt separation claw solenoid) [8]. 6. Reinstall the above parts following the removal steps in reverse. III DIS./ASSEMBLY Note:
• When having reinstalled the solenoid bar, [8] check to see if the shaft [9] of SD1 (belt sepa- ration claw solenoid) moves smoothly while sliding it. [7] [4] [5] [6] [3] [2] [1] 3-52