REGISTRATION/ADU/REVERSE/PAPER EXIT hp Color 9850mfp 10.4 Replacing the transfer ground plate unit and the 2nd transfer roller L A. Periodically replaced parts/cycle • Transfer ground plate unit: Every 1,000,000 cop- • 2nd transfer roller L: Every 200,000 copies ies B. Procedure 1. Remove the separation corona unit[1]. (See " 10.3 Replacing the separation corona unit .") 2. Remove the screw [2] and then remove the [4] transfer ground plate unit [3]. 3. Remove 2 stop rings [5]. 4. Slide each of 2 bearings [6] to the outside and remove the 2nd transfer roller L [4]. 5. Remove 2 bearings [6] from the 2nd transfer III DIS./ASSEMBLY 6. Reinstall the above parts following the removal roller L [4].
[1] [6] steps in reverse. Note: • Be careful not to touch with bare hands the 2nd transfer roller L [4] on any sections other than the shaft section. • When installing the 2nd transfer roller L, install it with the dent on the roller shaft [5] [6] [5] [3] [2] comes to the rear of the engine (instead of coming to the side contacting with the trans- fer earth plate). 3-108