hp Color 9850mfp REGISTRATION/ADU/REVERSE/PAPER EXIT 5. Remove the screw [1] and then remove the knob [2]. [12] [13] [16] [17] [9] 6. Remove the paper exit mounting plate F [3] and the paper exit open/close spring F [4]. 7. Remove two screw [5] and then remove the bearing [6]. 8. Remove the E-ring [7] and then remove the paper exit drive pulley 1 [8] and the pin [9]. 9. Remove the E-ring [10] and then remove the paper exit drive gear 4 [11] and the pin [12]. [7] [8] [10] [11] [14] [15] 10. Remove the bearing [13], paper exit mounting plate R [14], curler 1 [15] and the paper exit open/close spring R [16]. 11. Slide the bearing [17] to the inside and remove 12.
Reinstall the above parts following the removal the decurler [18]. steps in reverse. [18] [5] [6] [5] Note: • When reinstalling the paper exit drive pulley 1 III DIS./ASSEMBLY [8], be sure to take note of the direction of the belt guide. • When the decurler roller is replaced, reset "5. Parts counter" and "1. Count of special [4] parts." If not, the fixing jam may occur. [1] [2] [3] 3-115