Q3228A PAPER FEED 3.3 Removing and reinstalling the conveyance belt Note: • Be careful not to touch the belt roller or avoid damage or crease on it. If touching it by hand, hold at the area of 20mm from the edges in the width direction. 1. Fix the hinge opening/closing angle adjusting 2. Open RADF [1] vertically. fixture at an angle of 90 degrees. 3. Slide 2 stoppers [3] in the upper part of the con- veyance belt [2] leftward and loosen. 4. Remove the drive interlocking belt [4] on the left lower inside of the conveyance belt [2]. 5. Remove the conveyance belt unit. Note:
• When reinstalling, fit the drive interlocking [3] [1] [2] [3] III DIS./ASSEMBLY belt to the conveyance belt unit securely. [4] 3-15