Q3224A *2 Upright stack The ejected booklet is stacked upright between the exit tray and the pusher plate. The exit tray is pressed against the pusher plate by the force of the constant force spring. [3] Booklet Ejection/Stack Control TUDB PS101 5V IN GND 2 UNIT EXPLANATION 5V IN GND PS114 Exit tray Pusher plate 5V IN GND PS113 Stacked booklets 5V IN GND PS108 5V IN GND PS110 5V IN GND 5V IN GND PS112 M106_CONT M106_F/R M107_CONT DRV MS3 M107 PS110_SIG PS111_SIG PS112_SIG DRV MS4 Constant force spring DRV DRV M106 FINISHER Holder plate The holder plate is driven by the M106 (holder) via the timing belt. The pusher plate is driven by the M107 (pusher) via gears.
The M106 and M107 are driven When the pusher plate is at the turnout position to open the booklet ejection path, the booklet is held stacked upright between the exit tray and the holder plate. finisher. The related signals are PS101 (entrance), by the TUDB (Trimmer drive board) under the control of the PS108 (exit), PS110 (upper limit), PS111 (lower limit), PS112 (pusher), PS113 (stacker full) and PS114 (stacker door). Exit tray Pusher plate Stacked booklet 1. Operation The ejection/stack operation differs between the trim mode (booklet is cut) and through mode (booklet is not cut). a.
Preparaton of booklet ejection to the stacker (1) Trim mode When the specified time lapses after trimming has completed and stopper release operation started, the M107 turns ON to move the pusher plate to the turnout position to open the booklet ejection path. Holder plate 2 - 12 PS111