Carousel motor (M1) The carousel motor is located behind the fan 1 housing. 1 Remove the top cover assembly (see page 232). 2 Remove the rear cover (see page 243). 3 Remove the formatter board and formatter pan (see page 254 and page 272). 4 Remove five screws from the sheet metal cover plate and lift it off. 5 Remove four screws from the fan 1 assembly (callout 1). 3 2 4 2 2 2 1 2 Figure 134. Fans 1 and 2 housing assemblies 6 Release two cable stays and unplug one connector on the right side of the assembly (callout 2) to remove the housing. 7 Remove one screw from the fan 2 assembly (callout 3).
8 Release one cable stay and unplug one connector from the fan 2 assembly (callout 4) to remove the housing. EN Rear assemblies 283