Transport belt motor 1 Remove the back cover (see page 315). 2 Remove all paper bins and the blind cover (see page 318). 3 Release the controller PCA assembly from the bottom of the frame (see page 327, steps 1 through 7). 4 Unplug the J8 connector on the multi-bin mailbox controller PCA (callout 1). 2 2 1 2 Figure 172. Transport belt motor 5 Remove two screws (and washers) on the transport belt motor (callout 2). CAUTION When removing the motor, do not damage the internal drive belt. 6 Gently pull out the motor. Notes about reinstalling:
Reroute the cable on the transport belt motor behind the flat cable, and connect it to the J8 connector on the multi-bin mailbox controller PCA (callout 1). Replace the internal drive belt onto the transport belt motor gear before replacing the screws that secure the motor to the frame. 322 Chapter 6 - Removal and replacement EN