4 Use the TX-10 screwdriver to remove the grounding screw (callout 1) and release the grounding cable. 5 Use the TX-20 screwdriver to remove two screws and their washers (callout 2) from the stapler. Note Keep the washers with the screws to make sure they are reinstalled. 1 2 2 Figure 201. Stapler removal (2 of 3) Note The stapler is affixed tightly to the carriage assembly. Once the two screws have been removed, the stapler is held in place by the two metal tabs located on the side of the stapler opposite the screws. 6 Use firm pressure to slide the stapler toward the tab side of the stapler, clearing the tabs. EN 3,000-sheet stapler/stacker and 3,000-sheet stacker 351