Configuration Menu Table 20. Configuration Menu Item Value Description/action POWERSAVE= 30 MIN 1 HOUR* 2 HOURS (8500 only) 3 HOURS 8 HOURS (8550 and some 8500 models) 10 SEC Sets the length of time after use before the printer switches to powersave mode. Note that the 10-second setting is for service personnel use. PERSONALITY= AUTO* PCL PS Allows the user to determine which personality will be the default for the printer. When AUTO is selected, the printer will determine which personality to use for each print job. Note: PCL support is not available at initial product introduction.
CLEARABLE WARNINGS= ON* JOB Determines the amount of time that a clearable warning is displayed on the printer control panel. If set to ON, then clearable warnings are displayed until G O is pressed. If set to JOB, then clearable warnings are displayed until the end of the print job. TONER LOW= CONTINUE* STOP Determines the printer response to consumable low and out messages (including TONER LOW, TRANSFER KIT OUT, FUSER LIFE OUT, and DRUM LIFE LOW). If set to CONTINUE, clear the message by pressing G O . If set to STOP, clear the message by replacing the consumable. NEW TONER CARTRIDGE= (8550 only) NO YES QUICK COPY JOBS = (8550 only) 0 to 50 The default is 32.
PRINT PS ERRORS= OFF* ON If the PostScript interpreter detects illegal commands, the job is canceled. If ON, an error page prints. If OFF, there is no indication that an error occurred. INITIALIZE DISK None Appears only if the appropriate printer hard disk is installed. Press S ELECT to initialize. * Default setting. 88 Chapter 3 - Operational overview EN