Multi-axis controllers Mechanical installation Important notes 5 5.4 5.4.1 Mounting procedure: E94AZJA-003 1. Prepare M5 threaded holes on the mounting plate according to the mounting grid. – Start on the left with the installation backplane of DC-supply module E94AZPNxxxx or with DC input module E94AZEX100. – Install the axis modules from the left to the right with decreasing rated power. 2. Screw the installation backplane onto the mounting plate. Do not yet tighten the screws. h – Use M5 screw and washer assembly or M5 hexagon socket screws with washer. – The screw joint in the installation backplane may jut out no more than 7 mm. 3. Align all components. 4.
Insert the busbars each towards the left device and tighten the screws. i / j – Tightening torque: 3.2 Nm ... 3.5 Nm (28 lb-in ... 31 lb-in). 5. Screw the components onto the mounting plate. – Tightening torque: 3.4 Nm (30 lb-in). 5.4-3 EDS94SPP101 EN 3.1-04/2007