Safety instructions General safety and application instructions for Lenze controllers 3 3.1 3.1 General safety and application instructions for Lenze controllers (According to: Low-Voltage Directive 73/23/EEC) General Depending on their degree of protection, some parts of Lenze controllers (frequency inverters, servo inverters, DC controllers) and their accessory componentscanbelive,movingandrotating duringoperation. Surfacescan be hot. Non-authorised removal of the required cover, inappropriate use, incorrect installation or operation, creates the risk of severe injury to persons or damage to material assets. For more information please see the documentation.
Alloperationsconcerningtransport,installation,andcommissioningaswell as maintenance must be carried out by qualified, skilled personnel (IEC 364 and CENELEC HD 384 or DIN VDE 0100 and IEC report 664 or DIN VDE 0110 and national regulations for the prevention of accidents must be observed). According to this basic safety information, qualified, skilled personnel are persons who are familiar with the assembly, installation, commissioning, and operation of the product and who have the qualifications necessary for their occupation. Application as directed Drive controllers are components which are designed for installation in electrical systems or machinery.
They are not to be used as domestic appliances, but only for industrial purposes according to EN 61000-3-2. When installing drive controllers into machines, commissioning of these controllers (i.e. the starting of operation as directed) is prohibited until it is proven that the machine corresponds to the regulations of the EC Directive 98/37/EC (Machinery Directive); EN 60204 must be observed. Commissioning (i.e. starting of operation as directed) is only allowed when there is compliance with the EMC Directive (89/336/EEC). The controllers meet the requirements of the Low-Voltage Directive 73/23/EEC. The harmonised standard EN 61800-5-1 applies to the controllers.
Thetechnicaldataaswellastheconnectionconditionscanbeobtainedfrom the nameplate and the documentation. They must be strictly observed. Warning: The controllers are products which can be installed in drive systems of category C2 according to EN 61800-3. These products can cause radio interference in residential areas. In this case, special measures can be necessary. Transport, storage Please observe the notes on transport, storage and appropriate handling. Observe the climatic conditions according to the technical data. Installation The controllers must be installed and cooled according to the instructions given in the corresponding documentation.
Ensure proper handling and avoid mechanical stress. Do not bend any components and do not change any insulation distances during transport or handling. Do not touch any electronic components and contacts. Controllers contain electrostatically sensitive components, which can easily be damaged by inappropriate handling. Do not damage or destroy any electrical components since this might endanger your health! 3.1-1 EDS94SPP101 EN 1.0-12/2005