A90 series Inverter User Guide Figure 4-2 Menu Mode Selection 4.2.1 All menu mode （ --A-- ） Press under the all menu mode to enter the level 2 to select any parameter.Press again to enter the level 3 to review or modify parameters. At the all menu mode, the example from power-on to change F03.28 to 5.28 is shown in Figure 4–3. Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Figure 4-3 Example from Power-on to Setting F03.28=5.28 Flash bit Under each menu mode, press to save parameter change. The difference is that after having saved the parameter:
it enters the next parameter under All menu modes; it enters the next user-defined parameter (as the sequence in F11.00 - F11.31) under User-defined mode; it enters the next non-factory parameter under non-factory defaults mode 。 Press to cancel parameter change under the level 3. 23