A90 series Inverter User Guide Table 9-2 Digital input terminal functions 48 F03 Output Terminal Function Group F03.00 Y1 Output Function 0：No Function Multifunction digital output terminal, see Table 9-3 1 ○ F03.02 R1 Output Function 7 ○ F03.05 Output Signal Type D7 D6 D5 D4 D3 D2 D1 D0 *** **0*0 〇 * * * * * R1 * Y1 0: Level signal 1: Single pulse F03.06 Positive/Negative Logic of Digital Output D7 D6 D5 D4 D3 D2 D1 D0 *** **0*0 〇 * * * * * R1 * Y1 0: Positive Logic, Enabled at On/Disabled at Off 1: Negative Logic, Disabled at On/Enabled at Off F03.08 Output Status Control at JOG D7 D6 D5 D4 D3 D2 D1 D0 00000 〇 * * * RE V FD T2 FDT 1 FA R RU N 0: Enabled at JOG 1:
Disabled at JOG F03.09 Y1 ON Delay Time 0.000～30.000 s 0.000 ● F03.10 Y1 OFF Delay Time 0.000～30.000 s 0.000 ● F03.13 R1 ON Delay Time 0.000～30.000 s 0.000 ● F03.14 R1 OFF Delay Time 0.000～30.000 s 0.000 ● F03.17 Y1 single pulse Output Time 0.001～30.000 s 0.250 ● F03.19 R1 single pulse Output Time 0.001～30.000 s 0.250 ● F03.21 Analog Output M1 0：Running Frequency (absolute value) Multi-function analog output terminals, see Table 9-4 0 〇 F03.27 M1 Output Offset -100.0～100.0 % 0.0 ● F03.28 M1 Output Gain -10.00～10.00 1.00 ● F03.31 PLC output terminal control logic selection D7 D6 D5 D4 D3 D2 D1 D0 * * * * * R1 * Y1 0: no output 1:
output **0*0 ● Set function Set function value value 0 No Function 26 Frequency Source Switching 1 Run Terminal “RUN” 27 Clear Timed Running time 2 Terminal “R/F” 28 Switch between Speed Control and Torque Control 3 3-Wire Sequence Stop Control 29 Torque Control Disabled 4 Forward JOG (FJOG) 30 Switch between Motor 1 and Motor 2 5 Reverse JOG (RJOG) 31 Simple PLC Status Reset 6 Terminal UP 32 Simple PLC Time Pause 7 Terminal DOWN 34 Counter Input（≤250Hz） 8 Clear UP/Down Offset 36 Counter Clear 9 Coast to Stop 37 Length Counter Input（≤250Hz）