/!t;~:~:l SAFETY PRECAUTIONS IT FUSES 1. There are three fuses within the whole computer. 2 in the system unit and 1 in the monitor. WARNING-REMOVE POWER CABLE BEFORE SERVICING 2. System Unit: . The main system fuse is readily accessible on the rear panel. The carrier is of the screw-in type, and requires a flat bladed screwdriver to remove. Type-20mm slow blow 240V - T2 Amp - Part Number 11002121 11SV-T3 Amp-Part Number 11002721 3. Power Supply: The power supply is protected by its own fuse within the power supply casing. Since the power supply will automatically shut down in the case of an external fault, the failure of this fuse indicates a fault within the unit itself.
Under no circumstances replace this fuse, but change the unit as an assembly-see overleaf for safety precautions concerning this assembly. 4. Monitor: The monitor is powered from the + 12V rail off the systems unit power supply. This rail is protected by a fuse within the monitor itself. It is located on the p.e.B. under the High Voltage Block component. Type -1 U" x 2 Amp - Part Number 11040021