Chapter 10 DeviceNet Communication Module AH10DNET 10.2.2 Parts 5 8 12 10.2.3 DeviceNet Communication Connector The connector is used on the connection to DeviceNet. Wire by using the connector enclosed with AH10DNET-5A. 1 2 3 4 5 Note: 1. Connect the 24 V DC network power supply between V+ and V-. 2. One 121 ohm terminal resistor may be needed to connect between white and blue signal wires. For more details, please refer to section 10.3.4.
10-5 1 2 3 4 10DNE T M N 6 S S 7 x101 78 x100 78 DR 1 DR 0 IN 1 IN 0 9 11 10 5 12341234 6 0 96 N ode Addres s 5 0 9 Number Name Description 1 Model name The name of the module 2 Seven-segment display A display 3 Address switch For setting the address 4 Function switch For setting the function 5 DeviceNet connection port For DeviceNet connection 6 MS indicator An indicator 7 NS indicator An indicator 8 Removable terminal The terminals for wiring 9 Label Nameplate 10 Set screw Fixing the module The connector is used to connect the module and the 11 Backplane interface backplane.
12 Projection Fixing the module Pin Signal Color Description 5 V+ Red 24 V DC 4 CAN H _ White Signal+ 3 - - Shielded wire 2 CAN L _ Blue Signal- 1 V- Black 0 V DC