AH500 Motion Control Module Manual States of devices Example 2 *1:Y0.1 is a dual output. When M0 is OFF, Y0.1 is controlled by M1. When M0 is ON, Y0.1 is controlled by M12. 5-20 States of contacts States of contacts States of output Device before the during the coils during the execution of CJ execution of CJ execution of CJ Y devices, M devices, S devices M1, M2, and M3 are OFF. M1, M2, and M3 are turned from OFF to ON. Y0.1*1, M20, and S1 are OFF. M1, M2, and M3 are ON. M1, M2, and M3 are turned from ON to OFF. Y0.1*1, M20, and S1 are ON. 10 millisecond timers M4 is OFF. M4 is turned from OFF to ON. The timer T0 does not count. M4 is ON. M4 is turned from ON to OFF.
The timer T0 stops counting immediately. When M0 is turned from ON to OFF, the timer T0 is reset to 0. M6 is OFF. M6 is turned from OFF to ON. The timer T240 does not count. M6 is ON. M6 is turned from ON to OFF. The timer T240 stops counting immediately. When M0 is turned from ON to OFF, the timer T240 is reset to 0. C0~C234 M7 and M10 are OFF. M10 is ON/OFF. The counter C0 does not count. M7 is OFF. M10 is ON/OFF. M10 is ON/OFF. C0 stops counting. After M0 is turned OFF, C0 will resume counting. Applied instructions M11 OFF M11 is turned from OFF to ON. The applied instructions are not executed. M11 ON M11 is turned from ON to OFF.
The applied instructions which are skipped are not executed, but API 53~API 59 and API 157~API 159 are still executed,