AOC-SIMLC/SIMLC+ User's Guide 6. Enable IP Access Control: Check this box to enable the function of IP Access Control. This function is used to limit user access to the network by identifying them by their IP addresses. (This function is available to the LAN interface only.) 7. Default Policy: :KHQLWHP,3$FFHVV&RQWUROVHWWRHQDEOHG\RXFDQVHOHFW HLWKHUDFFHSWRUGURSDOORZLQJDFFHVVRUGHQ\LQJDFFHVVDFFRUGLQJWRSUHGH - їQHGUXOHV Note ,IWKLVRSWLRQLVVHWWRGURSDQG\RXGRQRWKDYHDVHWRIUXOHV that will accept the internet connection, then the internet connection over LAN is impossible. In this case, you need to change your security settings via modem or by disabling the IP Access Control.) 8. Rule#:
Enter a rule number in the box for a command (or commands) that will be used by the IP Access Control. 9. IP/Mask: Enter the IP Address or an IP Address Range for which the command(s) will be applied. 10. Policy: This item instructs the IPMI what to do with the matching packages. ( Note: The sequence or the order of the rules is important. The rules are checked in the ascending order until a rule matches. All rules below the matching one will be ignored. The default policy applies if no matching rules are found.) 11. Append: Select this option to add IP Address/Mask, rules or commands to the existing ones. 12. Insert:
Select this option to insert IP Address/Mask, rules or commands to the existing ones. 13. Replace: Select this option to replace an old IP Address/Mask, rule or command with a new one. 14. Delete: Select this option to delete (a part of) an existing IP Address/Mask, rule or command. 15. User Blocking: This window allows you to set the conditions how a user is blocked. 16. Max. Number of Failed Logins: Enter the maximum number of failed attempts or failed logins allowed for a user. If the number of failed logins or attempts exceeds this maximum number allowed, the user will be blocked from system. Note:
,IWKLVER[LVOHIWHPSW\WKHXVHULVDOORZHGWRWU\WRORJLQWRWKHVHUYHULQїQLWHO\ For network security, this is not recommended. 17. Block Time (Minutes): Enter the number of minutes allowed for a user to at- tempt to login. If the user fails to login within this time allowed, the user will be blocked from system. Note: ,IWKLVER[LVOHIWHPSW\WKHXVHULVDOORZHGWRWU\WRORJLQWRWKHVHUYHULQїQLWHO\ For network security, this is not recommended. 3-30