AOC-SIMSO/SIMSO+ User's Guide i./ii. Local Drive List : The box displays a list of local drives available for remote ac cess. Select from the list a local drive that you want to make accessible for a remote server. iii. Refresh : Click this button to refresh the local drive list. iv. Write Support : Check this button to allow the remote operating system to have write access to the drive that you have selected. This function allows a user to alter, overwrite, erase and destroy data stored in the drive selected. This feature should only be used with non-critical data. When "Write Support" is checked, the warning message as shown below will display.
Read the warning message carefully before enabling this function. Warning Message v. Connect : Click this button to make the drive you have selected accessible for re mote console interaction. Once you have clicked "connect," users logged in remote servers will have access to the local drive that you have selected. vi. Disconnect : Click this button to cancel the connection established between a lo cal drive and a remote server. Once you click this button, the drive you have selected will not be accessible for remote console interface. vii. Sending Commands : This functions allows the user to issue a pre-defined com mand to a remote server for execution.
To use this function, you need to click the hot keys displayed on the upper right corner of the screen as shown below. ( Note : Hot keys are the commands that have been pre-defined and pre-stored in a remote consoles.) Click Button 7 "Ctrl+Alt+Delete" as shown on Page 3-49 to send the command "Ctrl+Alt+Delete" to the remote server for execution. Once you have clicked on the button, a message displays, asking you if you really want to send "Ctrl+Alt+Delete" as shown in the picture on the next page. Click "Yes" to confirm it or click "Cancel" to stop sending the command for remote execution. 3-50