Configuring Application Hosting on Front-Panel Trunk Ports In application-hosting trunk-configuration mode, all the allowed AppGigabitEthernet VLAN ports are connected to a container. Native and VLAN-tagged frames are transmitted and received by the container guest interface. Only one container guest interface can be mapped to the AppGigabitEthernet trunk port. In Cisco IOS XE Gibraltar 16.2.1, you can configure an app-ID in either application-hosting trunk configuration mode or application-hosting VLAN-access configuration mode; but not in both modes. In Cisco IOS XE Amsterdam 17.1.1 and later releases, concurrent configuration of both trunk and vlan-access ports is supported.
SUMMARY STEPS 1. enable 2. configure terminal 3. interface AppGigabitEthernet number 4. switchport trunk allowed vlan vlan-ID 5. switchport mode trunk 6. exit 7. app-hosting appid name 8. app-vnic AppGigabitEthernet trunk 9. guest-interface guest-interface-number 10. end DETAILED STEPS Procedure Application Hosting Configuring Application Hosting on Front-Panel Trunk Ports Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface AppGigabitEthernet number Example:
Device(config)# interface AppGigabitEthernet 1/0/1 Configures the AppGigabitEthernet and enters interface configuration mode. • For stackable switches, the number argument is switch-number/0/1. Step 4 switchport trunk allowed vlan vlan-ID Example: Device(config-if)# switchport trunk allowed vlan 10-12,20 Configures the list of VLANs allowed on the trunk. Application Hosting 17