Delta Electronics — 6.17.2 Explanation of Real-time Clock Instructions

AS Series Programming Manual When the DST state is ON and in mode 2, the operand and descriptions are shown below. 3. This instruction is to enable / disable the daylight saving time function. Whether the contact is normally open or close will not affect the daylight saving time setting. (refer to example 2 for more details on how to switch the contact M0 OFF=>ON) You can reset the daylight saving time by executing the instruction again. There is no need to disable and then enable this function to reset the daylight saving time. 4.

When setting the daylight saving time to start on April 1 st and to end on September 1 st , and the duration is 60 minutes; _6 the real-time clock goes like below. 6-512 Operand Description S5 Time that changed due to daylight saving time; unit: minute D The DST state is ON (enabled). Operand Description S Function code is 7, indicating the DST state is ON and in mode 2. S1 The month to start daylight saving time S2 S2+1 S2: settings for the week to start daylight saving time S2+1: on which weekday of the S2 S3 The month to end daylight saving time S4 S4+1 S4: settings for the week to end daylight saving time S4+1:

on which weekday of the S4 S5 Time that changed due to daylight saving time; unit: minute Operand The DST state is ON (enabled). Daylight saving time function disabled Daylight saving time function enabled 1st March, 3 o’clock 1st March, 3 o’clock 31st March, 3 o’clock 31st March, 3 o’clock 1st April, 3 o’clock 1st April, 4 o’clock 1st May, 3 o’clock 1st May, 4 o’clock 1st June, 3 o’clock 1st June, 4 o’clock 1st July, 3 o’clock, 1st July, 4 o’clock 1st August, 3 o’clock 1st August, 4 o’clock, 31st August, 3 o’clock 31st August, 4 o’clock 1st September, 3 o’clock 1st September, 3 o’clock