omron — Applying the Appearance and Layout Parameters

Applying the Appearance and Layout Parameters Applying Layout Parameters to a Single Item This example shows how to apply Layout (size and location) parameters to precisely position and size a but- ton. It is also possible to simply drag the button to the desired location on the form, and then drag the handles on the button to size it, as desired. However, if you want to position or size the button (or other tool) to specific values, it is recommended that you enter those values, as described in the following steps. 1. In the UI Form Designer, drag a Button tool onto your UI Form. 2. Select the button. 3. In the Properties area, scroll down to the Layout group. 4.

Set the Layout parameters to the values shown in the following table. 5. The button appearance is set to the new values, as shown in the following figure. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 1027 Parameter Value Anchor Top, Left Location 50, 75 X 50 Y 75 Size 100, 50 Width 100 Height 50