Deploying the Custom User Interface Deploying the Custom User Interface After you create your custom UI, you can start ACE so that it automatically presents the UI to the oper- ator. This is done by starting the ACE software with the "loadui" parameter, which loads a specified user interface. There are several methods for doing this, which are described in the following sections. NOTE: The following procedures reference the "Load Workspace at Startup" option, which auto- matically loads a specified workspace when starting the ACE software. For details on this option, see Sys- tem Options on page 104.
If you do not have this option enabled, then you must use the datafile command-line parameter to load a specified workspace. Using the User Interface Deployment Tool The ACE software includes a User Interface Deployment tool, which is used to select UI deployment options and then create a shortcut based on those selections. To use the User Interface Deployment tool: 1. On the UI Designer toolbar, click the Deploy UI icon ( ). The User Interface Deployment tool opens. User Interface Deployment Tool with Options Selected 2. To apply a custom icon to the shortcut, use the browse button ( ) to locate and select the icon (.ICO) file on your PC.
After the icon file is selected, it is displayed in the Icon window to the left of the file path. 3. To create a shortcut with custom connection parameters, select the Use Custom Connection Para- meters option. By default (without the check box activated), the connection parameters used are those specified on the main form of the User Interface Designer. The custom connection parameters are described in the following table. ACE User's Guide, 3.6.x 18316-000 Rev A Page 1082